K2-MARINE, INC.

 

 

 

2007 BlackJack 224

 

Hull Form:

  1. 15 degree Deadrise – Rough water capacity combined with shallow water performance.
  2. Carolina flare bow entry – Dryer, smoother ride in chop water.
  3. Spray reduction chine – Turns water down and away.                                                
  4. Four lifting stakes – Quicker and better tracking
  5. Pocket Transom – Better hole shot speed and improved shallow water capability.  
  6. Transom hull extensions – Offsets heavier weight of engine
  7. Aft tumble-home – Easier access to water and fish

B.J.S.F.1.jpg (703793 bytes)                                      B.J.S.F.2.jpg (595676 bytes)

click on  photo's to enlarge

 

Construction

100% Composite construction – no wood, no rot!

3" Transom thickness – No flex, no cracking!

Foam filled fiberglass grid stringer system – Stiffer and lighter

100% Handlaid hull and deck - Better strength and lighter weight

Infactory cored compression molded hatches – Better fit and quality assurance and color match.

Premium quality gel-coats and resins

Molded fiberglass tubs and boxes – No cheap plastic!

Cormat cored sides – Reduces print and adds stiffness

Cored decks – No flexing of floors

All under deck compartments drain to bilge

Foam flotation exceeds Coast Guard requirements

All screws backed with composite panels or aluminum plate

Deck Layout and Features:

Pop up anchor cleats

Anchor locker

Ten cubic feet bow storage

B.J.S.F.4.jpg (331107 bytes)

All dry storage boxes                                                      

O-Ring and slam close latches

Locking rod storage with protective tubes

Wide flat gunwale top – step or site usage

Easy clean non-skid pattern

Forward fish box- insulated with thru – hull drain

Under gunwale rod storage with protective rod tubes

Large insulated center livewell with recirculator and fill

Two aft compartment for battery, oil and misc. storageB.J.S.F.5.jpg (382090 bytes)

 

 

Two forward storage boxes

1½ Splashwell drains – no brass to corrode

Recessed cast stainless steel hinges- strong and no rattle

Four gunwale rod holders

Custom Whitley cleats

Two custom drift anchor cleats

Features and Hardware:

Cast stainless hinges – not stamped or plated

Cast stainless rod holders with plastic inserts – strong and durable

Hydraulic steering with cast stainless steel wheel with knob

Removable windscreenB.J.S.F.6.jpg (519209 bytes)

 

 

Stainless 1 inch handrail

Forward livewell in console with fill and recirculator

1½" drains and overflows

Heavy gunwale trim with stainless insert

Aluminum leaning post with storage under seat, 4 rod holders and foot rest

94 quart ice chest under leaning postB.J.S.F.3.jpg (515094 bytes)

 

 

Wiring harness loom wrapped for chaff protection

6 gauge trolling motor harness with circuit breaker protection and tilt switch

All switches are circuit breaker protected

Separate accessory fuse panel for up to six extra circuits

50 AMP circuit breaker protection with main battery switch

On deck courtesy lights

Lighted livewells

Horn

Recessed SS navigation lights in hull

½" SS bow and stern eyes

Custom color coordinated upholstery

See and Sea Trial this Boat as well as the Awesome Frontier, both boats from the 2nd generation of the Kenner family, Bill and Gary Kenner.  

Contact K2 Marine:

Phone: (479) 885-0520

http://k2marine.com

 

 For further information call 772-519-0482

or e-mail

alteenanglers@aol.com

alb@teenanglers.org